You know the fat bat bastard that sit on this board and uses his own power to deliver me this ?
Tell us with this good condition, if you can believe it will work like usual one.
After 2 sets of memory, I attempt to order another type of DDR4 to realy see this working. But all the other piece except the DDR3 which actually have to order during the return and the second-delivery. It show inside the protector cup or pad should remain over and not lock into the clamp. Or I guess I do have to order a microscope or a digital eyes to re-correct the pin on the socket. You are right it's distorted and probably all the corner-side from the press of the cup. It should be apparently for keeping them safe.... (Apparently bad publicity for Canadian company, it's not a glove set in a used box for baseball but it look like ).
DDR3 is on the left one, DDR4 on the Right.
So someday I will horribly fall with the question, which one between DDR3 or DDR4 will leave for teacher. They had the right to test my own ATR compilation from s3m format into mpeg music format and hit through a virtual dos emulator the same electric shutdown... Of course they had right to report it was with one of the back-plane here.
So one going into return and hope it will work. I will either buy DDR3 for gamer around 2133Mhz or apparently 2400Mhz exist and probably found a set of non-ECC DDR4 to test it out. But out of buzzer I can really tell which is the beep signal mean.
And look closer about right side on green dimm we can se the notch of the the DDR4 which is not equal to each side of the rail. While on the orange layout of the DDR3 dimm they are equal in side between each rail. DDR3 have 240 pins and solder under seems to be in 2.5mm and you can count 4 group of 60 pins. On the DDR4 side under the board it's tinier than DDR3 socket and look like 2.0mm and count for 288 pins.
I will probably expanse more than 2 times the amount predicted will have a test to test. Because it's not say I will buy another GTX550Ti, I will switch and have the opportunity to test and report the speed between X99 DDR3 and X99 in DDR4, but actually both loosing due to lack of the material and apparently adaptable it should support one of the non-ecc, buffered, high-frequency DDR.
And removing the cooling of the NVME 2T disk it interfere with the ring for the cooler of LGA2011-3. I dare If I can craft something in metal for the LGA cooler and let the coolance 2-pipe being able to cool the Blue disk brand. Or stiff it on a FENVI 1x adapter they are now offering it into the retail but belong the video card I own it's about 5mm free I have in size to put a card here... I don't know but they are as small form to fit into a cube and sell it into G11-cube or something...